Comparison between magnetic resonance imaging, computed tomography, and arthrography to identify artificially induced cartilage defects of the equine carpal joints

Abstract While articular cartilage changes are considered to be one of the initial events in the pathological cascade leading to osteoarthritis, these changes remain difficult to detect using conventional diagnostic imaging modalities such as plain radiography. The aim of this prospective, experimental, methods comparison study was to compare the sensitivity of magnetic resonance imaging (MRI), magnetic resonance arthrography, computed tomography (CT), and CT arthrography in the detection of artificially induced articular cartilage defects in the equine carpal joints. Defects were created in the antebrachiocarpal and middle carpal joint using curettage by a board‐certified equine surgeon. Normal articular cartilage thickness varied from a maximum of 1.22 mm at the level of the distal aspect of the radius to a minimum of 0.17 mm in the proximal articular surface of the third carpal bone. Regarding cartilaginous defect measurements the remaining cartilaginous bed range from a maximum of 0.776 mm in the partial thickness defects, and 0 mm (defect reaches the subchondral bone) when total thickness defect were made. Computed tomography and magnetic resonance imaging were performed followed by CT arthrography and magnetic resonance arthrography after antebrachiocarpal and middle carpal intraarticular contrast administration. All images were reviewed by two board‐certified veterinary radiologists, both of whom were blinded to the location, presence of, and thickness of the ca...
Source: Veterinary Radiology and Ultrasound - Category: Veterinary Research Authors: Tags: ORIGINAL INVESTIGATION Source Type: research