Adhesion, unfolding forces, and molecular elasticity of fibronectin coatings: An atomic force microscopy study

In this study we have investigated the adhesion and mechanical properties of fibronectin coatings. The coatings were also used to study the role of the residence time and the influence of the loading rate in nonspecific interactions. The results showed that the adhesion force between silica and fibronectin increased with loading rate delivering similar values for residence times of 1 and 2 s. Further analysis indicated that the distance to the transition state was about 0.5 nm. Moreover, the adhesion force did not vary with the loading rate for contact time of 0 s. The unfolding of fibronectin domains also depended of the Dwell time (no unfolding events were observed for zero residence time). Applied loads of 2 nN were able to stretch the fibronectin layer up to 200 nm and to unfold the three fibronectin domains, which were similar for a Dwell time of 1 and 2 s. However, the unfolding length increased with loading rate: below 2.5 µm s−1 the obtained lengths matched the value of FN I (13.5 nm), while for higher speeds the measured values corresponded to the lengths of FN II (18 nm) and FN III (27 nm). This investigation has answered and opened new questions about the mechanical stability and function of fibronectin coatings. The results have also raised theoretical questions about the difference between specific and nonspecific interactions to be addressed in future work. Residence time plays a crucial role in non‐specific Si3N4 ‐ fibronectin interactions. Adhesion f...
Source: Microscopy Research and Technique - Category: Laboratory Medicine Authors: Tags: RESEARCH ARTICLE Source Type: research