Experimental Study on Micro Hole Drilling Using Ultrashort Pulse Laser Radiation

Publication date: 2016 Source:Physics Procedia, Volume 83 Author(s): Andreas Gruner, Joerg Schille, Udo Loeschner This paper discusses latest results obtained in micro hole percussion drilling in stainless steel. In the investigations a femtosecond laser source was used emitting 220 fs pulses at 1.03μm wavelength, whereas the spot size amounted to 31μm. Thereby, important process parameters like pulse energy, pulse repetition frequency, and pulse number were varied over a wide range in order to evaluate their influence both on the micro hole geometry like hole diameter, roundness, taper angle, and on the drilling quality such as thermal modification and melting residues. First, the required number of pulses for through hole drilling was estimated for material thicknesses ranging between 25μm and 1mm. It was found, that the polarization state of the laser beam has a considerable impact on micro hole formation. Therefore, linear and circular polarized laser radiation was applied. Finally, optimum parameters for highest available drilling quality and speed were identified.

Source: Physics Procedia - September 17, 2016 Category: Physics Source Type: research